Reason: if both controllers are untouched the control is in the middle. You cannot have 2 controllers parallel on the same control unit. I will not discuss this further, this is simply how prosim works. this is just one example of what can happen if prosim is bypassed. As long the control is moving surfaces willmove, even without hidraulics, the load control will then make the controls heavy.Īlso, rudder and aileron trim may not work properly if controls are assigned in P3D. I don´t need to explain too much, but how can you simulate heavy controls with spring loaded controls? This can only be done properly with load control systems. So no reason what so ever to use prosim calibration?īy the way PMDG can simulate hydraulic faliure and make the controls feel heavy eaven if you assign them in fsuipc. What advanced system simulations uses the controls input in prosim and send another output value? Can it simulate jammed controls, is it possible to set a special curve. What is it doing if Ther is hydraulic faliure.
Why? What is prosim doing with the controls. ProSim is a system simulation, thus inputs should be sent to ProSim, not P3D.
0 kommentar(er)
